A portable power station is the most expensive thing in your rig that isn't bolted down - and a ratchet strap over the handle is not a mounting plan. Every power station mount in this collection starts as a 3D scan of the actual unit, so the cradle follows the real curves of the case instead of hoping 'universal' lands close enough. Bolt it down once and it stays planted through washboard, two-track, and the occasional unplanned detour.

The lineup covers the stations people actually run: mounting rails for the EcoFlow Delta 2 and Delta 3, a dedicated EcoFlow Delta 2 Max tie-down, and an Anker SOLIX C1000 mount for Gen 1 or Gen 2. Hauling a fridge, cooler, or battery box instead? The multi-use mount set gives odd-shaped gear the same no-rattle hold.

Every mount is printed in Michigan from carbon-fiber-reinforced PETG or UV-stable ASA, because a closed-up rig in July gets hot enough to turn bargain plastic into taffy. Stainless hardware comes in the box, the load paths are reinforced where the weight actually sits, and every design gets beaten on real Michigan trails before it earns a listing. Prototypes that crack go in the failure pile, not the store.

Building out a camper van, hardwiring an RV bay, or running a truck-bed drawer system? A proper portable power station tie-down means the battery is still where you left it when the road gets stupid - no slow creep across the floor, no chewed-up corners, no rattle soundtrack. Use the fit finder at the top of this page to match your exact unit, and if your station isn't on the list, send a message. If it exists, I can probably mount it.

Free U.S. shipping on orders over $55. Built to order in 3-7 days by one guy in Michigan who actually uses this stuff.